Cli Commands - NETGEAR 7000 Series Administration Manual

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
Figure 9-22
The example is shown as CLI commands and as a Web interface procedure.

CLI Commands

To use the CLI to isolate VLANs on a Layer 3 switch by using ACLs, enter the following CLI
commands:
Create VLAN 24, add port 1/0/24 to it, and assign IP address 192.168.24.1 to it.
(Netgear Switch) #vlan database
(Netgear Switch) (Vlan)#vlan 24
(Netgear Switch) (Vlan)#vlan routing 24
(Netgear Switch) (Vlan)#exit
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/24
(Netgear Switch) (Interface 1/0/24)#vlan participation include 24
(Netgear Switch) (Interface 1/0/24)#vlan pvid 24
(Netgear Switch) (Interface 1/0/24)#exit
(Netgear Switch) (Config)#interface vlan 24
(Netgear Switch) (Interface-vlan 24)#routing
(Netgear Switch) (Interface-vlan 24)#ip address 192.168.24.1 255.255.255.0
(Netgear Switch) (Interface-vlan 24)#exit
(Netgear Switch) (Config)#exit
9-24
v1.0, May 2008
Access Control Lists (ACLs)