Web Interface Procedure - NETGEAR 7000 Series Administration Manual

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
Create ACL 103 to permit all other traffic.
(Netgear Switch) (Config)#access-list 103 permit ip any any
Deny all traffic with destination IP address 192.168.48.0/24 and permit all
other traffic.
(Netgear Switch) (Config)#interface 1/0/24
(Netgear Switch) (Interface 1/0/24)#ip access-group 102 in 1
(Netgear Switch) (Interface 1/0/24)#ip access-group 103 in 2
(Netgear Switch) (Interface 1/0/24)#exit
Deny all traffic with destination IP address 192.168.24.0/24 and permit all
other traffic.
(Netgear Switch) (Config)#interface 1/0/48
(Netgear Switch) (Interface 1/0/48)#ip access-group 101 in 1
(Netgear Switch) (Interface 1/0/48)#ip access-group 103 in 2
(Netgear Switch) (Interface 1/0/48)#exit

Web Interface Procedure

To use the Web interface to isolate VLANs on a Layer 3 switch by using ACLs, proceed as
follows:
1. Create VLAN 24 with IP address 192.168.24.1:
a. From the main menu, select Routing > VLAN > VLAN Routing Wizard. A screen similar
to the following displays.
Figure 9-23
9-26
v1.0, May 2008
Access Control Lists (ACLs)