Cli Example - NETGEAR 7000 Series Administration Manual

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2

CLI Example

The following shows an example of using the traceroute command to determine how many hops
there are to the destination. The command output shows each IP address the packet passes through
and how long it takes to get there. In this example, the packet takes 16 hops to reach its destination.
(Netgear Switch) #traceroute?
<ipaddr> Enter IP address.
(Netgear Switch) #traceroute 216.109.118.74 ?
<cr> Press Enter to execute the command.
<port> Enter port no.
(Netgear Switch) #traceroute 216.109.118.74
Tracing route over a maximum of 20 hops
1 10.254.24.1
2 10.254.253.1
3 63.237.23.33
4 63.144.4.1
5 63.144.1.141
6 205.171.21.89
7 205.171.8.154
8 205.171.8.222
9 205.171.251.34
10 209.244.219.181
11 209.244.11.9
12 4.68.121.146
13 4.79.228.2
14 216.115.96.185
15 216.109.120.203
16 216.109.118.74
14-2
40 ms 9 ms
30 ms 49 ms
29 ms 10 ms
39 ms 63 ms
70 ms 50 ms
39 ms 70 ms
70 ms 50 ms
70 ms 50 ms
60 ms 90 ms
60 ms 70 ms
60 ms 60 ms
50 ms 70 ms
60 ms 60 ms
110 ms 59 ms
70 ms 66 ms
78 ms 121 ms
v1.0, May 2008
10 ms
21 ms
10 ms
67 ms
50 ms
50 ms
70 ms
80 ms
50 ms
70 ms
50 ms
60 ms
60 ms
70 ms
95 ms
69 ms
Traceroute