Example #4: (Config) Monitor Session 1 Mode - NETGEAR 7000 Series Administration Manual

port, and what is enabled or disabled on the port.
(Netgear Switch Routing) #show port 0/7
Intf Type
1/0/7 Mirror
(Netgear Switch Routing) #show port 0/8
Admin
Intf Type Mode
---- ---- ------
1/0/8 Probe Enable

Example #4: (Config) monitor session 1 mode

To set up port mirroring, specify the monitor session, then the mode.
(Netgear Switch Routing)(Config)#monitor?
session Configure port mirroring.
(Netgear Switch Routing)(Config)#monitor session?
<1-1> Session number.
(Netgear Switch Routing)(Config)#monitor session 1?
destination Configure the probe interface.
mode Enable/Disable port mirroring session.
source Configure the source interface.
(Netgear Switch Routing)(Config)#monitor session 1 mode?
<cr> Press Enter to execute the command.
(Netgear Switch Routing)(Config)#monitor session 1 mode
Port Mirroring
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
Admin Physical
Mode Mode
Enable Auto
Physical
Mode
--------
Auto
v1.0, May 2008
Physical Link
Status Status
Down
Physical Link
Status Status
-------- ------
Down
Link LACP
Trap Mode
Enable Enable
Link LACP
Trap Mode
---- ----
Enable Enable
17-3