Process; Ip Acl Examples; Example #1: Set Up An Ip Acl With Two Rules - NETGEAR 7000 Series Administration Manual
Netgear managed switch administration guide
Hide thumbs
Also See for 7000 Series:
- Administration manual (344 pages) ,
- Installation manual (2 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
Process
To configure ACLs, follow these steps:
•
Create an ACL by specifying a name (MAC ACL) or a number (IP ACL)
•
Add new rules to the ACL
•
Configure the match criteria for the rules
•
Apply the ACL to one or more interfaces
IP ACL Examples
Example #1: Set up an IP ACL with Two Rules
The script in this section shows you how to set up an IP ACL with two rules, one applicable to
TCP traffic and one to UDP traffic. The content of the two rules is the same. TCP and UDP
packets will only be accepted by the 7000 Series Managed Switch if the source and destination
stations have IP addresses that fall within the defined sets.
Figure 9-1
The following is an example of configuring ACL support on a 7000 Series Managed Switch.
Access Control Lists (ACLs)
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
v1.0, May 2008
9-3
Advertisement
Table of Contents
