Advertisement
C
H
A
S
Y
To change the + to - (or vice versa), move the
cwsor there, and press the -(or
the +).
Enter the desired
time in the LOCATE
TIME
window using the numeric keys. Then hold SHIFT
and press ENTER. 'I& entered time will be loaded
o" the Inal",
Enter the desired time directly in the menu screen,
as explained below :
(I) Hold the CLR key and press the ? key,
OOz~O@OO will start blinking in the LOCATE
TIME
window,
to show you are in Direct
Keying In mode.
(2) Press numbers
on the numeric
keypad and
they are directly
entered
in the T/C:Offset
IlIe"".
(3) Press ENTER to saw the setting.
If you press ESCAPE
instead of ENTER, the
entered numbers are cleared and the display is
switched back to the initial screen,
Tip to consider :
When the cursor is to the right of the subframe section, if
you hold down the +/- key, the subframe numbers will
increment fast. The same will occur to the frame, second,
minute, and hour numbers if you continue to hold down
the key.
To enter +12:00:00:00.00
(maximum
offset time) :
You cannot enter with the + and - keys. Use the numeric
keys instead. When the numbers show in the LOCATE
TIME window, hold SHIFT and press ENTER.
An alternative
is to press CLR + 2 before operating the
numeric keys ; then the numbers are directly entered in
the menu screen.
(2) Auto Offset Entry (to frame aaw&
only)
You can capture
the current
difference
between
the
master and slave timecode
numbers
and put it into the
offset mcmory o" the fly.
1. Display the T/C : Offset menu.
2. At the desired moment,
hit ENTER. The difference
between
the master and slave timecode
numbers
at
that moment will show in the menu,
I
f
the
slave and
master
are
already
synciq
:
'Ilw slave
will directly
be offset and synchronize
to the master
keeping the offset time distance.
I
f
CHASE has not been pressed already
: Press CHASE.
To see the timecode numbers from the master, prw
MENU to get to the "T/C : External" menu. (The timecode
type from the mastcr also then show in the LCD screen.)
To see how much the DA-88 is apart from the master,
press the MENU until you access the "T/C : Abs Diff"
menu ; then, if you want to, press the + or-key
to switch
the display to "T/C : Rel Diff'.
-
To disable the offset sync : At the "T/C : Offset" menu,
hold the + or-key
and press the other. The offset display
1s reset to zero, Note, there is no way of temporarily
switching off the offset sync function. Until you reset the
offset display, the slave remains offset.
11-4 DUBBING AUDIO AND TIMECODE
AT
ONE TIME BETWEEN
TWO DA- 8BS
The original relationships
between the audio, ABS times
and timecode
numbers
can be copied
without
any
alterations whatever,
'Ihc SY-88 should be installed in both the master (source)
and slave (target) DA-88s. The following optional cables
are also "ecessary:
0
PW-88s sync cable
0
PW-88D dubbing cable
Synchronization
in this application
is ABS-time
based
(not timecode based).
1
Advertisement
