Advertisement
CHAPTER4: OPERATlONSGlJlDE
1 4-6 PUNCH-IN
RECORDING
1
0 Entering
a Crossfade
Click-free punch in and out of record is ensured by a crossfade action which defaults
Time
to 10 milliseconds.
If you want longer crossfades :
cl
0 Rehearsal
To switch the display back to Absolute time indication mode :
When the LCD screen reads :
press the plus or minus key, The "Relative" will change to "Absolute."
First, check to see that the recording source is plugged into the correct input jack on
the rear of the DA which is currently under remote control, and which contains the
tape you wish to correct (punch) (i.e., into input 2 for punching in on track 2 etc.).
1. Access the X-Fade Time menu screen. It will look like this :
(71
If any other crossfade
time has locally been entered on the DA, that time will
show.
2. Enter numbers by pressing the + key. Each time you press the key, the number
will increment by IO ms, up to 90 ms,
To decrement the number, press the -key.
3. Once the desired longer time than IO ms is displayed
(it should be blinking),
press ENTER.
The display will glow solid,
0 To switch all DAs (1 to 6) to the same crossfade time, select machine I and "All"
at the Key Mode menu, then enter the desired time at the X-Fade Time screen.
0
With the DA-88 : Check to see that REPEAT is not activated. If it is, press the
key to turn its LED off or RHSL cannot operate.
0
You can abort reheana.1 by pressing CLEAR at any time when RHSL is blinking
or on solid.
0
If the exact punch-in and out points are already known to you, you can enter those
time points with the numeric keys into the LOCATE TIME window, so they can
be stored in the IN and OUT memories. Othcwisc,
specify both points on the fly
as instructed here.
Advertisement
