Advertisement
1 11-1 SETTING A PARK POSITION
ILl Automatic
Entry
4.
When you access the Park Position
menu screen, it
will look like this :
Press
CHASE to locak- the DA-88
to the same
timecode address as the master,
When the relative dit?ercncc be&vcen the master and
slave timecode numbers becomes 00~00, as shown on
the screen, sum the master.
Press ESCAPE.
The lag in the DA-88's play time will be entered into
the Park Position
screen,
and the Test mode will
swkch "Off," aummatically.
NOTE
ESCAPE
has no effect if pressed when the slave is
more than 2 seconds behind the master.
0 Fine Tuning the Current Park Position
At the Park Position screen with the Test mode switched
"Off," you can trim the current park position time using
the plus and minus keys.
-
0
The park position time display will be reset to zero if
you press the plus key a.t the same time as the minus
key when the Test mode is Off.
1 II-2
SYNCHRONIZATION
I
1. Check to see that the DA-88 is set up to meet your
requirements.
Before continuing,
if you are using moldpIe DA-EXs,
consider the capability of "Enabling/disabling
CHASE
mode on all machines 2.6 (...)'I explained
in the right
column of this page.
2. Press CHASE
"CHASE" will appear in the LOCATE TIME window.
If you then press
"I" o" the keypad,
the LOCK
STATUS I indicamr will flash rapidly, and once both
machines are locked together, it will flash slowly,
Once
locked together, the slave will duplicate
every
action
of the master
autcnna~ically,
be it rewind,
normal play, fast-forward,
or stop.
Error Message
"E,
[LflC#l.
If this message appears, first switch CLOCK to INT, then
at the Reference T/C n~enu screen (p.10 . I), select the
same time code type as the one from the master.
To sss ths master (external) timecode numbers :
Display the "T/C : External" screen (Group 4).
To disable synchronization :
Press CHASE. The LOCATE
TIME display
will read
"CHASE."
Then, press
I on the keypad.
The LOCK
STATUS 1 indicator will turn off,
Enabling/Disabling CHASE mode on all machines 2-6,
at one time :
Just press CHASE + 0. If the lowest numbered
slave is
NOT in CHASE
mode at this moment,
it will go into
CHASE mode, and so will ail other slaves. Or they will
all exit the CHASE mode if the lowest numbered slave is
in CHASE mode,
II-3
OFFSET SYNC
An offset
can
be entered
up to a maximum
of
+l2$QOO%O.~
or down to a minimum of -l2:CQ00%0.00,
either before putting the slave (DA-88) into "chase" mode or
when the master and slave we syncing.
(1) Manual Entry
I. Access the T/C : Offset menu (Group 4).
[X)
2. Enter the necessary offset time in any of three ways :
0 USC the + and -keys.
To move the cursor, turn the JOG wheel or hold
SHIFT and prws the + or-key,
1
1
.
Advertisement
