Locate Time - Tascam RC-848 Owner's Manual

CHAPTER 5 : SYNCHRONIZING MULTIPLE DA'S
3.
4.
5.
6.
Locate the slave to the desired sync point.
Press
MACHINE
then
1,
and locate the mister to the desired sync point.
Access the Machine Offset screen. It should look like this :
The display on the upper line in the screen shows the number that corresponds
to
the slave under control. 'Ibe number will increment as you turn the SHUTTLE
knob or press MENU while holding SHIFT.
Press ENTER.
The RC-848 automatically calculates and displays the necessary offset value on
the Swx".
Repeat for other slaves as required.
(2) On
the Numeric Keypad
Access the Machine Offset screen, and turn the SHUTTLE knob or hold SHIFT
and press MENU to display the number that corresponds to the slave you want to
offset.
Enter the desired offset value on the
numeric keypad into the
LOCATE TIME
window.
Once the desired value is displayed, hold
SHIFT and
press
ENTER.
The
LOCATE TIME display will be read into the swan.
Repeat for other slaves as required.
(3) Direct Entry in the Machine Offset Menu
Access the Machine Offset screen, and either turn the SHUTTLE knob or hold
SHIFT and press MENU to display the number that corresponds to the slave you
want to offset.
Hold CLR and press f.
OOzO@OO9O will start blinking in the LOCATE TIME window, to show that the
unit is in Direct Keying-in mode.
Enter the desired offset value on the numeric keypad.
As you type numbers, they will be entered directly in the menu screen, not into
the LOCATE TIME window.
To change the + (ahead) to - (behind), and vice versa, press either of the plus and
minus keys.
5.3