Advertisement
CHAPTER 4 : OPERATIONS GUIOE
You can also enter track delay time in
1
millisecond
steps within the limits of -4
to IS0 milliseconds
(IS0 ms is nearly equal to 7200 Fs). If you want to, hold
SHIFT and press ESCAPE to change "Fs" to "ms." Then enter the desired time
with the + and-keys;
then, press ENTER.
To defeat the entered delay time, hold either the plus or the minus key and press the
other. The display on the lower line will be reset to zero.
Setting
one and the satne delay time for all (I to 6) tracks
simultaneously
:
Either operate the SHUTTLE
knob, or hold SHIFT and press MENU, until "All"
is
displayed on the upper line, 'Ilxn,
enter the desired time with the plus and minus
keys, Once the desired time is displayed, press ENTER.
1 4-5
RELATIVE
REFERENCE
TIME
INDICATION
1
ccl
El
-
The TAPE TIME
display can be switched to show clapsed time from an optionally
specified point on the tape inserted in machine I.
Access the Display Time menu screen (Group 2). It will look like this
:
Press the +/-key.
The "Absolute"
will change to "Relative."
Press the v key when the tape reaches the point you want to define as a "zero"
reference point. The TAPE TIME
at that tnotne"t
will be read into the LOCATE
TIME window.
You cztn also enter the desired time with the numeric keys.
Press STR, then press 0 two times
on the keypad.
"00"
will
show
in the
MEMORY
NO.window.
From now on the TAPE TIME display will give elapsed time from the time point
you have just stored into the MEMORY
NO.00 register until you establish a new
reference point or switch the display back to Absolute mode.
To locate the tape to your reference point
:
Press RCL, and press 0 two times to specify MEMORY
NO.00. The LOCATE
TIME
display will read O@OQO@OO. Then press LOC.
If ZI Locate Preroll time has been entered, the tape will be located to ZI point plus pre-
roll zts defined by the locate prc-roll parameter.
To establish a new reference point
:
Repeat the above procedure. Exh
time a new rcfcrcncc point is stored into memory,
the previous tnemory is erased.
4.10
Advertisement
