Advertisement
1 4-7
COPYING
TRACKS (DA-38
only)
4-8 SHUTTLE
MONITOR (DA-38 only)
To copy track
3 m
track 5 for example
:
I.
Access the Track Copy maw (Group Z), which will look like this :
[?$%-z?g
You cannot access this menu if the DA-38 is not currently under remote control,
2. To select a txgct track, enter "5" in the "Tr" field in any of three ways
:
0
Turn the
SHUTTLE
knob ;
0 Hold SHIFT and press MENU ; or
0 Press the REC FUNCTION switch that corresponds to track 5 of the DA-38,
(Note, it's not necessarily the no.5 switch. It depends on the connection.)
3. To select a source track, press the + key until "Tape 3" shows. If you go past it,
press the -key.
4. Press ENTER to change the "Off'
to "On".
5. Making
sure that only track 5 is record-enabled,
hold REC and press PLAY to
start copying,
In a similar way, you cart copy tracks of one DA-3X to tracks of another, For tnore
information,
see the DA-38's manual.
When you rotate the SHUTTLE
knob for reel rocking to locate specific points cm the
tape, what you hear depends on whether the shuttlc monitor mode is enabled or not,
as shown in the table below,
To enable or disable the shuttle monitor function
:
1.
Access the Shuttle Monitor
me"" (Group I), which will look like this
:
You camtot access this mc"u if the DA-38 is not currently under remote control.
-
4.14
Advertisement
