Advertisement
CHAPTER 5 : SYNCHRONIZING MULTIPLE OA'S
Cl Syncing
with Offset
0 Fine Tuning
Offset
Values
-
+
00
Ll Selecting
a Key Mode
4. Press ENTER to store the setting.
If you press ESCAPE
instead of ENTER, the emercd numbers are cleared and
you'll exit the current mode.
5. Repeat for other slaves as required.
(4) Using the Plus and Minus Keys
Perfom
step I above, then use the plus and minus keys to display the desired
offset value on the lower line in the screen.
To move the cursor, turn the JOG wheel or hold SHIFT and prtx
the plus or
minus key.
To change the + (ahead) to - (behind), and vice versa, press either of the plus and
minus keys.
Repeat for other slaves as required.
Press CHASE then pre?.s a number. The slave that corresponds
to the number pressed
will be axoloca~ed
to a point either ahead or behind the master as defined by the
offset value. Repeat for each of other slaves. Or you can "se the 'All Chase On'
function explained on page 5 - 2.
On the Machine Offset screen move the cursor to the right of the "frames" column
using either the JOG wheel or the SHIFT and plus or minus key so the xr~en looks
like this :
Then, hold down either the plus or minus key. The frame numbers will increment,
and after a while, overfiow, causing the second numbers to increment.
Unless you
release
the key, the minute numbers
and then the hour numbers
will increment
likewise.
To disable offsets :
Access the Machine Offset menu showing the desired machine number, and hold the
+
or -key
and press the other. The display will be cleared to zero.
At the Key Mode men" yo" ca" select whether the ALL SAFE/REC
READY, ALL
INPUT, AUTO INPUT, and INSERT keys have effect on the master machine only or
on all the rnas~cr and slave machines a.t once.
I. When machine
I (the master)
is under control,
access the Key Mode menu
(Group I) to check or change the current selection, 'Ibe menu screen will look
like this :
5*4
Advertisement
