Advertisement
CHAPTER6: CONTROLLlNGOTHEREGLIlPMENTFROMACCESSORY"l"
Settings at the Event Pal/Width menu are valid to Events
refexmced to an IN memory, too.
I.
2.
3.
-
4.
5.
6.
7.
r
Access the Ret In Event menu screen (Group I), It
will look like this :
Change the In Event number on the upper line as
necessary by operating the SHUTTLE knob or by
holding SHIFT and pressing MENU.
Enter the desired frame numbers in the Reaction field
by operating the + and -keys.
(Seconds can also be
entered if necessary.)
After having entered the correct reaction time, first
access the Event OdOff menu, which looks like this :
then, hold SHIFT and press ESCAPE to access the In
Event menu, which looks like this :
Enter the same number as in step 2 above, and the
current IN memory point will show on the second line
of the menu and to the right will show the fwnes you
have entered in step 3 above.
Press ENTER and the "Off'
will change to "On" to
show that the In Event is enabled.
Repeat for other In Events as required,
NOTE
-
The
time data the RC-848 uses to control events
comes from the DA, and only by this data travel time
(a few frames) will the event lag behind the time
points you've selected at the mew.
Advertisement
