Advertisement
33. CUE STR key
Hitting this key capturcs the currem TAPE TIME on the
fly and directly stores it into memory. That time point is
read into the LOCATE TIME window. Each time you hit
this key, a new cue point is stored into the next available
memory,
Storing
cue points
without
specifying
any
MEMORY
NO.
is
explained
in
the
section,
AUTOLOCATOR
FUNCTIONS,
page 4.6.
34. Transport
controls
REW : winds the tape at high speed in rwcrsc.
F FWD : winds the tape at high speed in the forward
diwxion.
STOP : stops any tape motion.
PLAY : starts the tape to play. If this is pressed during
record, the transport drops out of record.
When controlling
the DA-88
If you want to send playback
signals
from the digital
outputs, access the "Output Timing" menu, then press the
+/- key to change the "Analog" to "Dig&al", At "Analog"
a compensation
circuit is activated to override the D/A-
A!D conversion time.
REC : This is a master record key. When you hold this
and press
PLAY,
the track
or tracks
whose
REC
FUNCTION
indicator
w.s blinking
will cntcr Record
mode. If you hit REC during play, the track(s) previously
selected
by the REC FUNCTION
switches
will punch
into record.
35. LOC key
Fast winds the tape to the curvat
LOCATE TIME point
which may have been recalled from memory or captured
on the fly with the v key or entcrcd with the numeric
keys.
0 Rear Panel
Thcrc is no connector
which accepts any control signal
from the exterior,
36. CONTRAST
knob
This controls the LCD display conuast
in continuously
variable degrees.
37. EXT 1 (ACCESSORY
1) connector
This 37.pin D-sub connector is connected to the parallel
port of analog tape machines,
For more information on the EXT I port, see Chapter 6.
38. EXT 2 (ACCESSORY
2) connector
This 15.pin D-sub connector is connected to the identical
connector
on TASCAM
analog tape machines
such as
l34/l34B,
644, 688 and 238 cassette decks, and TSR-S,
MSR-l6/l6S
and MSR- 24/24S open-reel
decks. The
TASCAM CD-601 playcr or the RC-701/601
CD remote
controller may ahcmaGvely be connected here. Transport
or Record Functions are accessible via this port,
39. EXT 3 (RS-422) connector
This 9.pin D-sub connector is for connection m a VTR or
other devices with RS-422 protocol,
-
For more information
on controlling
from EXT 3, set
Chapter
8 and also the scction,
USING THE RC-848
WITH THE SY-88.
40. REMOTE OUT connector
This
connects
to the TASCAM
DA-88/38
digital
mulGtrack
recorder.
If you have multiple
recorders,
connect the SYNC OUT of the first recorder to the SYNC
IN of the second, the SYNC OUT of the second to the
SYNC IN of the third, and so o". If you connect seven or
more recorders (up to 16) in this way, tbc rcmow CHASE
key cannot control them.
You have to press their local
CHASE keys.
-
Advertisement
