Advertisement
1 7-2 TASCAM OPEN-REEL
RECORDERS
0 Connections
1. Make sore that your machine is turned off,
2. Check to see that the baud rate is set to 9603 on the
machine. If it is at any other position, set it to 9600.
3. Connect
the remote
EXT
2 (ACCESSORY
2)
connector
to your
machine's
ACCESSORY
2
connector using the optional PW-8SAC2 cable,
0 Machine Selection
1. Press
MACHINE,
"Select" will show in the LOCATE TIME window
2. Press 8. "E2" will light up in the MACHINE window,
0 Remote Functions
Changed/Limited
REC FUNCTION switches
1-8, 1-16 cn I-24
(depending
on the number of tracks
available on your machine)
: Only these switches act as
the REC FUNCTION
switchcs.
28 : Twos on the machine's SYNC LOCK function
29 : Turns off SYNC LOCK.
31 : Turns oo the machine's INSERT function,
32 : Turns off INSERT,
33 : Turns on the machine's ALL INPUT function.
34 : Turns off ALL INPUT,
36 : Turns oo the machine's AUTO INPUT function,
37 : Turns off AUTO INPUT.
39 : Turns on the machine's AUTO PLAY function,
40 : Turns off AUTO PLAY,
48 : When E2 is under remote control, the remote TAPE
TIME display acts as a conventional
tape counter, and
pressing
switch
48 resets
it to 00.00. The local tape
counter also is reset at the sane time,
All other REC FUNCTION
switches are locked out,
TAPE TIME display
This acts as a
conventional
tape counter,
providing
clapsed time from any point on the tape specified
as a
starting point (0.00.00) by pressing the REC FUNCTION
#48 key. Reading
is op to a maximum
of I hour, 39
minutes, 59 seconds, and down to a minimum of -I hour,
39 minutes, 59 seconds. When the tape goes past these
limits, the coontcr is automatically
rcsct to 0.00.00,
When the tape rewinds past the 00.00 point, a "-" will
show in the H(our)
window.
Numeric keys
When a TASCAM
reel-to-reel
deck is under remote
control,
yoo can store a maximum
of 20 autolocating
points into the MEMORY
NO.00
to I9 registers.
So,
when STR or RCL is activated,
pressing
20 or higher
numbers on the keypad has no effect.
STOP LED
Flashes when the machine's right tension arm is dropped
to its "off' position for edit porposw
7.2
Advertisement
