Advertisement
,-
CHAPTEtl4: OPERATIONSGUIDE
Q Actual, Auto Punch In
and Out
0 Setting preroll and
pos.Woll times
The INSERT
and RHSL LEDs should still light solid. All tracks should be in Safe
mode except the one you intend to record on.
IO. Press AUTO IN/OUT so
its
LED starts blinking.
The RHSL LED that was on solid will turn off.
11,
Press
PLAY.
'Ilx
tape
will punch in and punch out of record at the preset points. After
a 3.
second (or optionally
set time)
postroll,
the AUTO
IN/OUT
LED
that was
blinking
will
glow solid and the tape will rewind,
stopping
at the preroll
start
point.
To review the result
:
Press
PLAY. The
tape will play to the postroll
end point, and r-wind,
stopping at the
preroll start point.
To record again using the same menvxy points :
Press
AUTO IN/OUT.
I&
LED
will s&n blinking
as before, then press PLAY.
To exit AUTO IN/OUT mode
:
Press
CLEAR.
The preroll time is factory preset to 5 seconds, and the postroll time is to 3 seconds.
You can only enter longer times than them.
Enter the desired time into the LOCATE
TIME window
with the numeric
keys.
The pre- and postroll times are second-accurate. To enter 6 seconds, press 6.0.0.
Effective
entries are up to a maximum of 59 minutes, 59 seconds.
Press STR,
Press PFlE (or POST)
to store
the time just entered into memory a.s the prcroll
(or
pos~roll) time.
If you press PRE after a preroll
time has
been entered, the point where the pmoll
starts from is displayed
in the LOCATE TIME
window.
So you can promptly
locate the tape to that point using LOC, and fine rime it with the
UP and
DOWN
keys.
Relationships
between the punch-in related modes and the RHSL and AUTO IN/OUT LEDs
4.13
Advertisement
