Advertisement
CHAPTER4: OPERATIONS GUIOE
13 Autolocating
to One
of the 99 Cue Points
.-
2. Press STR
then enter a two-digit MEMORY NO. to store the fine tuned cw point
into memory. The previous cue point in that n~emory is erased.
To entirely
ChanQe any recalled we point
:
Perform one of the "Setting Cue Points" procedures. Each time you store a new we
point into any MEMORY NO. register, the previous memory in that register is
erased.
Before actually autolocating the tape to any cw point, know this :
You can locate the tape to a point plus pre-roll time if you "se the locate pre-roll
parameter. 'ILK default time for the locate pre-roll parameter is "0".
To enter a Locate Preroll time
:
1. Access the Locate Preroll meno ween (Group 2). It will look like this
:
2. Press the +/- key. The "See" number will change in
I
second increments.
To move the cwwr to the "MS
section, turn the
JOG
wheel to the left, An
alternative is to hold
SHIFT
and preys the
minus
key.
You can reset the Locate Preroll time to zero by pressing the plus key a.t the fame
time a~ the minus key,
To autolocate the ta.pe to a cw point
:
Enter the desired MEMORY NO. with the numeric keys,
The cw point stored in that register will be recalled into the LOCATE TIME
window,
The tape will automatically be located to the time point currently shown in the
LOCATE TIME window, or to the locate point plus pre-roll as defined by the
locate pre-roll paranlet~r,
At the end of the autolocation function, the tape will stop unless AUTO PLAY is
engaged.
4.7
Advertisement
