Table of Contents
Advertisement
Installing an xSeries 3-Pack Ultra 160 Hot-Swap Expansion Kit
You can install an xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit in your server
to provide three additional hot-swap hard disk drives.
To install a xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit:
1. Review the information in "Before you begin" on page 42 and in "Safety
2. Turn off the server and peripheral devices and disconnect all external cables
3. Release the side latches to remove the filler panels from the bays below the
4. Refer to the documentation provided with the option to assemble the hot-swap
5. Slide the hot-swap expansion option into the bays and attach it to the server
6. Refer to the documentation provided with the option to complete the
7. If you have other options to install or remove, do so now; otherwise, go to
Replacing a hot-swap fan assembly
Your server comes with three hot-swap fan assemblies. You do not need to turn off
the power to the server to replace a hot-swap fan assembly.
information" on page 107 and "Handling static-sensitive devices" on page 43.
and power cords; then, remove the cover and bezel. (See "Removing the cover
and bezel" on page 44.)
CD-ROM drive.
expansion option.
with the screws provided in the kit.
installation of the option. (See "System board internal cable connectors" on
page 36 for locations of the cable connectors on the system board.)
"Installing the server cover and bezel" on page 62.
Filler panels
Hot-swap expansion option
Installing options
61
Advertisement
Table of Contents
