Table of Contents
Advertisement
3. Open the cover on the air-baffle assembly.
4. Determine the connectors into which you will install the DIMMs. (See Table 3 on
5. To install the DIMMs, repeat the following steps for each DIMM that you install:
6. Close the cover on the air-baffle assembly.
7. If you have other options to install or remove, do so now; otherwise, go to
Installing a hot-swap drive
Your server supports a maximum of six 1-inch (26 mm) slim-high, 3.5-inch,
hot-swap hard disk drives in the standard hot-swap bays. In the tower model, the
hot-swap bays are arranged vertically in the standard hard disk drive cage; the bay
numbers are 0 through 5 (from bottom to top). In the rack configuration, the
hot-swap bays are arranged horizontally in the standard hard disk drive cage; the
bay numbers are 0 through 5 (from left to right). In the tower model, bays 0 through
5 are below the removable-media drive bays. In the rack configuration, bays 0
through 5 are to the left of the removable-media drive bays.
Note: It is not necessary to remove the air-baffle assembly to perform this step.
Air-baffle assembly
cover
page 27.)
a. Turn the DIMM so that the DIMM keys align correctly with the connector on
the system board.
Attention:
To avoid breaking the retaining clips or damaging the DIMM
connectors, handle the clips gently.
b. Insert the DIMM by pressing the DIMM straight into the connector. Be sure
that the retaining clips snap into the closed positions.
Note: If a gap exists between the DIMM and the retaining clips, the DIMM
has not been properly installed. In this case, open the retaining clips
and remove the DIMM; then, reinsert the DIMM.
"Completing the installation" on page 35.
Chapter 2. Installing options
29
Advertisement
Table of Contents
