Installing An Xseries 3-Pack Ultra160 Hot-Swap Expansion Kit - IBM eserver xSeries 232 8668 Hardware Maintenance Manual

11. If the drive is a SCSI device:
a. Make sure the drive is not a hard disk drive.
b. Connect one of the connectors on the SCSI cable to the back of the drive.
c. Connect the other end of the SCSI cable to the SCSI channel B connector
on the system board, or to an optional SCSI adapter, as appropriate. See
"SCSI connector pin-number assignments" on page 93 for the location of
the SCSI connectors. See also "Ultra160 SCSI ports" on page 91 for
information about SCSI connections and devices.
12. Connect a power cable to the back of the drive. Power cables for
non-hot-swap drives come installed in your server. The connectors are keyed
and can be inserted only one way.
13. If you are installing another non-hot-swap drive, do so at this time.
Otherwise, continue with the next step.
14. If you have other options to install or remove, do so now; otherwise, replace
the cover (see "Installing the cover" on page 79 for details).

Installing an xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit

You can install an xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit in your server
to support three additional hot-swap hard disk drives.
Note: The illustrations in this document might differ slightly from your hardware.
To install an xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit:
1. Review the information in "Before you begin" on page 41, in "Important safety
information" on page v, and "Handling static-sensitive devices" on page 42.
2. Turn off the server and peripheral devices and disconnect all external cables
and power cords; then, remove the cover and bezel. (See "Removing the
left-side cover (tower model)" on page 43.)
3. Release the sidelights to remove the filler panels from the bays above the
CD-ROM drive.
4. Refer to the documentation provided with the option to assemble the hot-swap
expansion option.
5. Slide the hot-swap expansion option into the bays, and attach it to the server
with the screws provided in the kit.
Installing non-hot-swap drives
Filler panels
Hot-swap
expansion option
59
Installing options