Table of Contents
Advertisement
10. Set the fan sink into place.
11. Press down and latch the spring retention clip on the back of the fan sink (the
12. Press down and latch the spring retention clip on the front of the fan sink (the
13. Plug the fan sink into the fan sink connector on the system board (J46). Make
14. Reinstall the air baffle. Make sure the sides of the air baffle fit inside the
15. Reinstall the fan 3 assembly and make sure that the connector engages.
16. If you have other options to install or remove, do so now; otherwise, go to
Installing a hot-swap power supply
Your server comes with one power supply. You can install an additional power
supply.
58
Hardware Maintenance Manual: xSeries 342 Model 1RX, 2RX, 1TG, 2TG
Microprocessor
release lever
Make sure the fan sink guide fits between the processor and the processor
socket.
Fan sink guide
side facing the back of the server).
side facing the front o f the server).
sure the cable is not in a position to interfere with the fan sink operation.
brackets on the server.
"Installing the server cover and bezel" on page 62.
Fan sink
(Remove thermal tape
liner on installation)
Ensure correct alignment
of fan sink, mounting clip,
and mounting socket
Spring retention clip
Advertisement
Table of Contents
