IBM xSeries 342 2RX Maintenance Manual page 100

Error Code/Symptom
162 (Device Configuration Error)
Note: Be sure to load the default settings
and any additional desired settings; then,
save the configura-tion.
163 (Real-Time Clock error)
164 (Memory configuration changed, see
"Memory settings" on page 32.)
175 (Hardware error)
176(Computer cover or cable cover was
removed without a key being used)
177, 178 (Security hardware error)
184 (Power-on password corrupted)
185 (Drive startup sequence information
corrupted)
186 (Security hardware control logic
failed)
187 (VPD serial number not set.)
188 (Bad EEPROM CRC #2)
189 (An attempt was made to access the
server with invalid passwords)
201 (Memory test error, see "Memory
Settings" on page 32.) If the server does
not have the latest level of BIOS installed,
update the BIOS to the latest level and
run the diagnostic program again.
229 (Cache error)
262 (DRAM parity configuration error)
289 (DIMM has been disabled the user or
system, see "Memory Settings" on page
32.)
301 (Keyboard or keyboard controller
error)
92
Hardware Maintenance Manual: xSeries 342 Model 1RX, 2RX, 1TG, 2TG
FRU/Action
1. Run Configuration/Setup
2. Battery
3. Failing Device
4. System Board
1. Run Configuration/Setup
2. Battery
3. System Board
1. Run Configuration/Setup
2. DIMM
3. System board
1. System Board
1. Run Configuration/Setup
2. System Board
3. C2 Security Switch
1. Run Configuration/Setup
2. System Board
1. Run Configuration/Setup
2. System Board
1. Run Configuration/Setup
2. System Board
1. Run Configuration/Setup
2. System Board
1. Set serial number in Setup
2. System Board
1. Run Configuration/Setup
2. System Board
1. Run Configuration/Setup, enter the administrator password
1. DIMM
2. System Board
1. Processor
2. Optional Processor (if installed)
1. Run configuration / setsup
2. Battery
3. System Board
1. Run Configuration/Setup, if disabled by user
2. Disabled DIMM, if not disabled by user.
1. Keyboard
2. System Board