Installing An Xseries 3-Pack Ultra160 Hot-Swap Expansion Kit - IBM eServer 342 xSeries User Reference Manual

Installing an xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit

t - s w a p e x p a n s i o n k i I n s t a l l i n g a h o t You can install an xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit in your server to
provide three additional hot-swap hard disk drives.
Note: The illustrations in this document might differ slightly from your hardware.
To install an xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit:
1. Review the information in "Before you begin" on page 35, "Safety information" on
2. Turn off the server and peripheral devices and disconnect all external cables and
3. Release the side latches to remove the filler panels from the bays below the CD-
4. Refer to the documentation provided with the option to assemble the hot-swap
5. Slide the hot-swap expansion option into the bays and attach it to the server with
6. Refer to the documentation provided with the option to complete the installation of
7. If you have other options to install or remove, do so now; otherwise, go to
64
IBM xSeries 342: User's Reference
page 37, and "Handling static-sensitive devices" on page 36.
power cords; then, remove the cover and bezel. (See "Removing the cover and
bezel" on page 43.)
ROM drive.
expansion option.
the screws provided in the kit.
the option. (See "System board internal cable connectors" on page 29 for
locations of the cable connectors on the system board.)
"Installing the server cover and bezel" on page 66.
Filler panels
Hot-swap expansion option