Finding Additional Information On Fmt; Adding Performance Modules On 9730 Systems - HP StoreAll 9730 Administrator's Manual

NOTE:
in turn the flash of the following components:
f. Once the FSN boots up, verify the software reports the FSN as Up, FailedOver by
enter the following command:
ibrix_server -l
g. Confirm the recommended flash was completed successfully by enter the following
command:
hpsp_fmt -fr server -o /tmp/fwrecommend.out
Verify that the Proposed Action column requires no more actions, and the Active
FW Version and Qualified FW Version columns display the same values.
h. Fail back your updated server by entering the following command:
ibrix_server -f -U -h server1
i. The failed-over Fusion Manager remains in nofmfailover mode until it is moved to passive
mode by using the following command:
ibrix_fm -m passive
NOTE:
j. Repeat steps a through h for the backup server component, in this example switch server1
with server2 in the commands.
k. Repeat steps a through I for each node that requires a firmware upgrade.
6. If you are upgrading to 6.3, you must complete the steps provided in the "After the upgrade"
section for your type of upgrade, as shown in the following table:
Type of upgrade
Online upgrades
Automated offline
upgrades
Manual offline
upgrades

Finding additional information on FMT

You can find additional information on FMT from the online help for FMT. To access the online
help for FMT, enter the hpsp_fmt command on the file system node console.

Adding performance modules on 9730 systems

See the HP StoreAll 9730 Storage Performance Module Installation Instructions for details about
installing the module on a StoreAll 9730 cluster. See the
140 Upgrading firmware
The -p switch in the failover operation lets you reboot the effected node and
BIOS
NIC
Power_Mgmt_Ctlr
SERVER_HDD
Smart_Array_Ctlr
Storage_Ctlr
A Fusion Manager cannot be moved from nofmfailover mode to active mode.
Complete the steps in this section
"After the upgrade" (page 14)
"After the upgrade" (page 15)
"After the upgrade" (page 17)
HP StoreAll Storage Installation Guide