Configuring The Storeall Cluster For Insight Remote Support - HP StoreAll 9730 Administrator's Manual

IMPORTANT:
Insight Manager:
1. Download ibrixMib.txt from /usr/local/ibrix/doc/.
2. Rename the file to ibrixMib.mib.
3. In HP Systems Insight Manager, complete the following steps:
a. Unregister the existing MIB by entering the following command:
<BASE>\mibs>mxmib -d ibrixMib.mib
b. Copy the ibrixMib.mib file to the <BASE>\mibs directory, and then enter the following
commands:
<BASE>\mibs>mcompile ibrixMib.mib
<BASE>\mibs>mxmib -a ibrixMib.cfg
For more information about the MIB, see the "Compiling and customizing MIBs" chapter in the HP
Systems Insight Manager User Guide, which is available at:
http://www.hp.com/go/insightmanagement/sim/
Click Support & Documents and then click Manuals. Navigate to the user guide.
Limitations
Note the following:
For StoreAll systems, the HP Insight Remote Support implementation is limited to hardware
events.
The X9720 CX storage device is not supported for HP Insight Remote Support.

Configuring the StoreAll cluster for Insight Remote Support

To enable X9720/9730 systems for remote support, you need to configure the Virtual SAS Manager,
Virtual Connect Manager, and Phone Home settings. All nodes in the cluster should be up when
you perform this step.
NOTE: Configuring Phone Home removes any previous StoreAll snmp configuration details and
populates the SNMP configuration with Phone Home configuration details. When Phone Home is
enabled, you cannot use ibrix_snmpagent to edit or change the snmp agent configuration.
However, you can use ibrix_snmptrap to add trapsink IPs and you can use ibrix_event to
associate events to the trapsink IPs.
Registering Onboard Administrator
The Onboard Administrator is registered automatically.
Configuring the Virtual SAS Manager
On 9730 systems, the SNMP service is disabled by default on the SAS switches. To enable the
SNMP service manually and provide the trapsink IP on all SAS switches, complete these steps:
1. Open the Virtual SAS Manager from the OA. Select OA IP > Interconnect Bays > SAS Switch
> Management Console.
2. On the Virtual SAS Manager, open the Maintain tab, click SAS Blade Switch, and select SNMP
Settings. On the dialog box, enable the SNMP service and supply the information needed for
alerts.
38 Getting started
You must compile and manually register the StoreAll MIB file by using HP Systems