HP StoreAll 9730 Administrator's Manual page 199

named ibrix that contains the installer program. For example, if you expand the tarball in
/root, the installer is in /root/ibrix.
5. Change to the installer directory if necessary and run the upgrade:
./ibrixupgrade -f
The installer upgrades both the management console software and the file serving node
software on this node.
6. Verify the status of the management console:
/etc/init.d/ibrix_fusionmanager status
The status command confirms whether the correct services are running. Output will be similar
to the following:
Fusion Manager Daemon (pid 18748) running...
7. Check /usr/local/ibrix/log/fusionserver.log for errors.
8. Upgrade the remaining management console node. Move the ibrix directory used in the
previous release to ibrix.old. Then expand the distribution tarball or mount the distribution
DVD in a directory of your choice. Expanding the tarball creates a subdirectory named ibrix
that contains the installer program. For example, if you expand the tarball in
nl
/root, the installer is in /root/ibrix.
9. Change to the installer directory if necessary and run the upgrade:
./ibrixupgrade -f
The installer upgrades both the management console software and the file serving node
software on the node.
10. On the node that was just upgraded and has its management console in maintenance mode,
move the management console back to passive mode:
<ibrixhome>/bin/ibrix_fm -m passive
The node now resumes its normal backup operation for the active management console.
Upgrading remaining file serving nodes
Complete the following steps on the remaining file serving nodes:
1. Move the <installer_dir>/ibrix directory used in the previous release installation to
ibrix.old. For example, if you expanded the tarball in /root during the previous StoreAll
installation on this node, the installer is in /root/ibrix.
2. Expand the distribution tarball or mount the distribution DVD in a directory of your choice.
Expanding the tarball creates a subdirectory named ibrix that contains the installer program.
For example, if you expand the tarball in /root, the installer is in /root/ibrix.
3. Change to the installer directory if necessary and execute the following command:
./ibrixupgrade -f
The upgrade automatically stops services and restarts them when the process is complete.
4. When the upgrade is complete, verify that the StoreAll software services are running on the
node:
/etc/init.d/ibrix_server status
The output should be similar to the following example. If the IAD service is not running on your
system, contact HP Support.
IBRIX Filesystem Drivers loaded
ibrcud is running.. pid 23325
IBRIX IAD Server (pid 23368) running...
5. Execute the following commands to verify that the ibrix and ipfs services are running:
lsmod|grep ibrix
ibrix 2323332 0 (unused)
lsmod|grep ipfs
Upgrading the StoreAll software to the 5.5 release 199