Checking The Status Of Statistics Tool Processes; Controlling Statistics Tool Processes - HP StoreAll 9730 Administrator's Manual

The following actions occur after a successful failover:
If Statstool processes were running before the failover, they are restarted. If the processes
were not running, they are not restarted.
The Statstool passive management console is installed on the StoreAll Fusion Manager in
maintenance mode.
Setrsync is run automatically on all cluster nodes from the current active Fusion Manager.
Loadfm is run automatically to present all file system data in the cluster to the active Fusion
Manager.
The stored cluster-level database generated before the Fusion Manager failover is moved to
the current active Fusion Manager, allowing you to request reports for the specified range if
pre-generated reports are not available under the Hourly, Daily and Weekly categories. See
"Generating reports" (page
NOTE:
the historical statistics database is not transferred to the current active Fusion Manager.
If configurable parameters were set before the failover, the parameters are retained after the
failover.
Check the /usr/local/ibrix/log/statstool/stats.log for any errors.
NOTE: The reports generated before failover will not be available on the current active Fusion
Manager.

Checking the status of Statistics tool processes

To determine the status of Statistics tool processes, run the following command:
#/etc/init.d/ibrix_statsmanager status
ibrix_statsmanager (pid
In the output, the pid is the process id of the "master" process.

Controlling Statistics tool processes

Statistics tool processes on all file serving nodes connected to the active Fusion Manager can be
controlled remotely from the active Fusion Manager. Use the ibrix_statscontrol tool to start
or stop the processes on all connected file serving nodes or on specified hostnames only.
Stop processes on all file serving nodes, including the Fusion Manager:
# /usr/local/ibrix/stats/bin/ibrix_statscontrol stopall
Start processes on all file serving nodes, including the Fusion Manager:
# /usr/local/ibrix/stats/bin/ibrix_statscontrol startall
Stop processes on specific file serving nodes:
# /usr/local/ibrix/stats/bin/ibrix_statscontrol stop <hostname1>
<hostname2> ..
Start processes on specific file serving nodes:
# /usr/local/ibrix/stats/bin/ibrix_statscontrol start <hostname1>
<hostname2> ..
111).
If the old active Fusion Manager is not available (pingable) for more than two days,
25322) is running...
Maintaining the Statistics tool 1 13