HP StoreAll 9730 Administrator's Manual page 138

1. Run the /opt/hp/platform/bin/hpsp_fmt -fr command to verify that the firmware
on this node and subsequent nodes in this cluster is correct and up-to-date. This command
should be performed before placing the cluster back into service.
The following figure shows an example of the firmware recommendation output and corrective
component upgrade flash:
IMPORTANT:
1. Server
2. Chassis
3. Storage
2. Do the following based on the Proposed Action and Severity:
Status in Proposed Action column
UPGRADE
UPGRADE
NONE or DOWNGRADE
NONE or DOWNGRADE
3. Perform the flash operation by entering the following command and then go to step 5:
hpsp_fmt -flash -c <components-name>
The following screen shot displays a successful flash operation.
138 Upgrading firmware
Upgrade the firmware in the following order:
Status in Severity column
MANDATORY
RECOMMENDED
MANDATORY
RECOMMENDED
Go to
Step 3
Step 3 is optional. However, it is
recommended to perform step 3 for
system stability and to avoid any
known issues.
Step 4
Step 4 is optional. However, it is
recommended to perform step 4 for
system stability and to avoid any
known issues.