Replacing The Friction Pad - Ricoh Aficio AP610N Quick Installation Manual

Hide thumbs Also See for Aficio AP610N:

Table of Contents

Replacing the Friction Pad

Replace all friction pad of the tray.

There are two kinds of friction pads.

One is for the paper tray (Tray 1), and

the other are for the paper feed unit(s)

(Tray 2, 3). The following procedure

shows how to replacing friction pad

of the paper tray (Tray1).

Lift the paper tray slightly, and

then pull it out until it stops.

Lift the front side of the tray, and

then pull it out of the printer.

Remove paper from the paper

tray. Place the tray upside down

on a flat surface.

Use a sharp-pointed item like a

ball-point pen, to release the two

catches that lock the friction pad.

❒ The friction pad may fall off

when the catches are released.

Place your hand over the fric-

tion pad while releasing the

❒ The friction pad spring may

come off. Be careful not to lose

the friction pad spring.

❒ The catches that lock the friction

pad are located at the very back.

Replacing the Maintenance Kit

Table of Contents