Ricoh Aficio AP610N Quick Installation Manual page 70

Configuration
E
Press the {U} or {T} key to select
Active Protocol, and then press
the {# Enter} key.
Active Protocol:
TCP/IP
The following example explains
activating TCP/IP.
The [Active] or [Not Active] selection
screen appears.
F
Press the {U} or {T} key to select
[Active] or [Not Active], and then
press the {# Enter} key.
TCP/IP:
5
*Active
After the settings are made, about
two seconds later, the screen re-
turns to the active protocol menu.
G
Set other protocols you need to set
in the same way.
H
Press the {Escape} key, the screen
returns to the network setup
menu.
Note
❒ The default is "Active".
❒ Leave unused protocols "Not
Active".
❒ Enable TCP/IP to use the Pure
IP environment of NetWare
5/5.1, NetWare 6/6.5.
I
If you use TCP/IP, assign the IP
address to the printer. Press the
{U} or {T} key to display [IP Ad-
dress], and then press the {# Enter}
key.
The current IP address appears on
the display.
To get the IP address for the print-
er, contact your network adminis-
trator.
64
J
Press the {U} or {T} key to enter
the left most entry field of the IP
address, and then press the {# En-
ter} key.
IP Address:
192.022.033.044
Press the {# Enter} key, the screen
changes, and the next field can
then be entered.
Note
❒ Do not set "011.022.033.044" as
the IP address.
❒ The value moves by 10 if the
{U} or {T} key is kept pressed.
❒ When the {# Enter} key is
pressed, the cursor moves to the
next field.
❒ To display the previous field,
press the {Escape} key.
❒ Press the {Escape} key when no
value is entered and the screen
will return to the network setup
menu, without the IP address
changing.
K
Make the other settings in the
same way, and then press the {#
Enter} key.
IP Address:
192.168.000.010
After the settings are made, about
two seconds later, the screen re-
turns to the network setup menu.
L
If you use TCP/IP, assign [Subnet
Mask] and [Gateway Address] fol-
lowing the same procedure for
entering the IP address.
M
When you use this machine in
DHCP environment, set DHCP to
"On".