Ricoh Aficio AP610N Quick Installation Manual page 73

E
Press the {U} or {T} key to select
the transmission mode of IEEE
802.11b, and then press the {# En-
ter} key.
Comm. Mode:
*802.11 Ad hoc
After the settings are made, about
two seconds later, the screen re-
turns to the IEEE 802.11b setting
menu.
Note
❒ The factory default is [802.11 Ad
hoc].
❒ To use an IEEE 802.11b card for
w h i c h t h e S S I D ( N e t w o r k
Name) setting is not necessary,
select [Ad hoc].
❒ The transmission mode of IEEE
802.11b can also be set using a
Web browser. For details, see
Web Image Monitor Help, and
"Using Web Image Monitor",
Software Guide.
F
If [802.11 Ad hoc] or [Ad hoc] is se-
lected for [Comm. Mode], set the
channel to use for transmission.
Note
❒ Confirm the network adminis-
trator for the channel to use.
G
Press the {U} or {T} key to dis-
play [Channel], and then press the
{# Enter} key.
The channel currently used ap-
pears on the display.
IEEE 802.11b (Wireless LAN) Configuration
H
Press the {U} or {T} key to enter
the channel, and then press the {#
Enter} key.
Channel:
(1-13)
I
Set [Trans. Speed] in the same way.
Note
❒ The factory default is [Auto]. If
you need to change the trans-
mitting speed depending on en-
vironment you are using, select
the appropriate transmitting
speed.
J
If [Infrastructure] or [802.11 Ad hoc]
is selected for [Comm. Mode], set
SSID to use for transmission.
Note
❒ Confirm the network adminis-
trator for SSID to use.
❒ SSID can also be set using a Web
browser. For details, see the
Web Image Monitor Help, and
"Using Web Image Monitor",
Software Guide.
K
Press the {U} or {T} key to dis-
play [SSID], and then press the {#
Enter} key.
The following message appears on
the display.
SSID:
View
If an SSID has been set, you can
check the set SSID. Press the {# En-
ter} key.
13
67
5