Ricoh Aficio AP610N Quick Installation Manual page 43

D
Pull out the handle of the control-
ler board.
E
Pull the handle, and then slide
the controller board out.
F
Place the controller board on a flat
surface.
G
The memory unit is installed in
the slot shown in the illustration
below.
Attaching Memory Unit Type C 256MB (SDRAM Module)
H
Remove the default memory unit
before installing a new memory
unit. Press down the levers on
both sides to remove the default
memory unit.
ZKGX370E
I
Align the notch of the memory
unit to the slot, and then push it
down until it clicks.
ZKGX260E
J
Match the controller board to the
top and bottom rail using the "T"
mark, and then slide it into the
printer slowly until it stops.
ZKDX021J
3
AGN016S
ZKGX130E
ZKGX250E
37