Ricoh Aficio AP610N Quick Installation Manual page 44

Installing Options
K
Push the handle of the controller
board until it clicks.
3
L
Fasten the controller board to the
printer with the two screws.
M
Align the power cable to the left
side groove of the duplex unit,
and then slide the duplex unit in
until it is connected to the printer.
If the duplex unit is not attached,
this step is not necessary.
38
Note
❒ Be sure to return the provided
screwdriver to its original posi-
tion on the inside of the front
cover.
❒ After finishing the installation,
you can check the memory unit
is properly installed: Print the
configuration page from the
"List/Test Print" menu. If it is
installed properly, you will see
the memory capacity for "Total
ZKGX380E
Memory".
❒ To expand memory, remove the
default SDRAM module, and
then install the SDRAM module
(256 MB). "Total Memory" will
be the size of SDRAM module
memory unit you installed.
❒ If the memory unit is not prop-
erly installed, repeat the proce-
dure from the start. If you
cannot install it properly even
after reinstallation, contact your
sales or service representative.
ZKGX270E
Reference
For printing the configuration
page, see p.28 "Test Printing".
ZKGX243E