Drum Rotation Motor; Ntc Heat Pump Circuit - Electrolux ENV06 Service Manual

11.15 Drum rotation motor

Detach the belt tensioner spring (2). This loosens the belt tensioner pulley
(3), which is attached to the motor.
Turn the motor towards the interior of the dryer. This loosens the drive belt
(4) which can now be removed.
Loosen the screws (S) which secure the front and rear motor brackets (5),
rotate 90° and remove the brackets.
IMPORTANT
In some models, a plastic spacer is inserted between the rear bushing and
the motor. Ensure that this spacer is correctly inserted when re-
assembling.

11.16 NTC heat pump circuit

The NTC (1) is housed in a special pocket fitted to the side of the
dehydration filter (3) in the heat pump circuit, between the condenser
and the evaporator. The NTC is secured by a spring (2).
To remove the NTC, press the spring to release the lower extremity
and remove the NTC.
2008-03 ADL 49/58 599 70 66 79