Operation Of The Appliance; Operation Of A Cycle; Operation In Pause Mode - Electrolux ENV06 Service Manual

4 Operation of the appliance

When the selector switch is turned from OFF to one of the drying programmes, the symbols or LEDs
corresponding to the drying phases light and the START/PAUSE LED begins to flash.
During this phase, the various options can be entered (the corresponding symbol(s) will light).
The display shows the maximum time for the drying cycle.
If an option is selected that is incompatible with the programme, the buzzer sounds and the display shows
"Err". The LEDs begin to flash.
If one or more options are entered, the time shown on the display will increase or decrease.
If the position of the selector is altered after entering the options, but before pressing START/PAUSE, the
options will be cancelled.

4.1 Operation of a cycle

To start the drying cycle, first use the selector to enter a drying programme. Then enter the desired option (if
any), and press START/PAUSE.
The LED corresponding to the START/PAUSE key remains lit and, simultaneously, the symbol
corresponding to the current phase lights. The display shows the maximum drying time.
The drying cycle comprises the following phases:
•
DRYING
If an automatic cycle has been selected, the duration will be the time required to remove the humidity until
the desired humidity level is reached.
If the cycle is timer-controlled, then its duration will be the time entered by the user.
•
COOLING
For timer-controlled cycles, the cooling phase has a maximum duration of 10 minutes. For automatic cycles,
the duration of the cooling phase may be shorter (this depends on the temperature inside the drum).
•
ANTI-CREASE
The duration of the anti-crease phase is 30 minutes.
The programme may not be modified after a drying programme has commenced.
If the position of the programme selector is changed, the LED corresponding to the START/PAUSE key
begins to flash and the buzzer sounds to warn the user that the operation is not compatible. "Err" is shown
on the display.
If any key is pressed, the LED corresponding to the START/PAUSE key begins to flash and the buzzer
sounds to warn the user that the operation is not compatible. "Err" is shown on the display.
The options permitted for each cycle can be entered only after selecting the drying programme with the
selector at the start of the cycle, or during a cycle but after pressing the START/PAUSE key.
To reset (cancel) a drying cycle, turn the selector to OFF.

4.2 Operation in PAUSE mode

If the START/PAUSE key is pressed while a dryer cycle is being performed, the dryer interrupts the cycle
and the LED corresponding to the START/PAUSE key flashes. In models with display, the time-to-elapse
until the end of the cycle is shown.
If the programme selector is turned, the buzzer will sound to warn the user that this operation is
incompatible.
In this status, only certain options can be modified (see table "OPTIONS" in the Instruction Booklet).
If a key is pressed with an option that is not permitted for the programme being performed, the buzzer
sounds to warn the user and "Err" is shown on the display.
Press the START/PAUSE key again to resume the cycle at the point at which it was interrupted.
2008-03 ADL 15/58 599 70 66 79