E 06 Drum Motor - Electrolux T4650 Service Manual

Service
manual
E 06 - Drum motor - Overheating protection (motor 2)
Error description
The thermal protection switch inside the drum motor is connected to the PCB.
This error indicates that the thermal protection switch, or the harness between the board
and the switch, has opened.
A defective PCB can also cause this error.
The dryer stops operating.
Error analysis
1. Is the motor
clogged by lint
or dust?
2. Does the
motor run
slowly or is the
rotor locked?
3. Unplug
motor control
connector P1
and P2 from the
PCB.
487 05 40 31
12. Error codes
YES
Clean the motor.
NO
Go to step 2.
Is the motor seized?
NO
Is there continuity
through the thermo fuse
for the drum (F8)?
Replace
YES
motor or clear
blockage.
Go to step .
Connect P1 and
P2. Does the
YES
error reoccur
when the motor
is restarted?
NO
Put the dryer
back into
operation.
NO
Is the motor
cold?
12
The error occurs
immediately.
YES
Replace the PCB
The error occurs
after a while's
YES
operation.
Defective motor
protection circuit
- replace the fan
motor or harness.
Check motor
YES
harness and con-
nector. Replace
motor/harness/
connector.
Wait until the
NO
motor is cold and
restart it.
12.9