11.19 Rear air duct
Detach the connector from the fan (2).
Remove the 18 screws which secure the air duct to the rear
panel. Do NOT remove the four screws (1) which secure the
fan.
List the air duct slightly and remove from the rear panel.
After removing the air duct assembly, remove the four screws
(1) and remove the fan (6). Separate the three components
which form the air duct assembly.
External cover (3).
Insulating layer (4).
Internal air duct (5).
11.20 PTC and motor overload cut-out
To access the overload cut-out PTC, insert a screwdriver into the slot and move the cover to the right.
To remove the overload cut-out PTC, remove the screw (1) which secures it to the compressor, and remove
the cable clamp (2).
Pull the entire overload cut-out PTC assembly outwards.
PTC overload cut-out
2008-03 ADL
51/58
599 70 66 79