13 Door reversibility
Open the filter compartment door
Remove the filter compartment door by removing the two
screws which secure the hinges (A) to the appliance.
Remove the masking plates (B) and (C) by levering off with a
flat screwdriver.
Remove the door lock latch (D) by pressing with a
screwdriver and fit it to the other side of the door (remember
to turn it upside down).
Unscrew the hinges (A) from the door and replace them on
the other side (rotate the hinges 180° before replacing).
Replace the masking plates (B) and (C) on the opposite
sides (again, rotate 180°).
Unscrew the two masking plates (E) from the front panel,
rotate them by 180°, and replace on the opposite side.
Remove the latch plate (F) by pushing it slightly upwards and
then tilting forward.
Press the release tab on the masking plate (G) and, at the
same time, push it downwards and tilt forward.
Move the latch plate (F) to the opposite side and use the
screw removed previously to secure it in position.
Move the masking plate (G) to the opposite side and insert so
that the tab enters the hole correctly.
Replace the door with the hinges now on the opposite side.
Insert and tighten the screws and check for correct alignment
and closing.
2008-03 ADL
58/58
599 70 66 79