Rear Air Duct Cover (Hot Air Circulation); Rear Air Duct Cover (Cold Air Circulation); Drum Rotation Motor - Electrolux EDR1000NEW Service Manual

13.6.3 Rear air duct cover (hot air circulation)

i. Remove the motor wiring from the anchor securing the wiring to the
duct cover.
j. Remove the three screws which secure it to the base and remove.

13.6.4 Rear air duct cover (cold air circulation)

k. Remove the screw and detach the duct cover from the three anchor
tabs (two upper lateral tabs, one lower tab) which secure it to the
base, and remove.

13.6.5 Drum rotation motor

l. After removing the covers from the two ducts, it is possible to
access the drum rotation motor.
m. Remove the belt tensioner spring.
n. Remove the screws which secure the front and rear motor support
brackets, rotate upwards and remove.
o. Rotate the entire motor block (motor + two fans) towards the interior
of the dryer, lift and remove (after removing the drive belt from the
fan).
p. Replacing the belt tensioner roller / drive belt
1. Spacer
2. Belt-tensioner roller with incorporated spacer
3. Elastic ring
4. Belt in central position
5. Leave two grooves free on each side of the pulley.
SOI/DT 2003-12 dmm
n-o
44/50
i
k
l
m
p
599 36 20-08