Disactivate Buzzer; Disactivate Buzzer (Not Only For The Selected Cycle); Start / Pause Key - Electrolux ENV06 Service Manual

3.9.1 Deactivate buzzer
The buzzer may be deactivated while the dryer is in programme selection (set-up) mode.
Press this key to enable the buzzer. The corresponding LED or symbol will light to indicate that the buzzer is
on. To disable this option, press the same key again.
The buzzer will continue to sound in the event of an alarm even if the normal buzzer function has been
disabled.
3.9.2 Deactivate buzzer (not only for the selected cycle)
This function should be selected during the selection (set-up) phase.
Valid for all models: Press keys 1 and 2
simultaneously for 5 seconds. The LED or symbol
corresponding to the buzzer will switch off and a
"BIP" will be heard
To re-activate the buzzer, press the same keys
again until the buzzer again sounds a "BIP".

3.10 START / PAUSE key

Start
When the selector is used to select a drying programme, the symbols for the three phases (drying, cooling
and anti-crease) light and the START/PAUSE LED begins to flash.
After selecting the desired options (if any), press this key to start the cycle. The corresponding LED will
remain lit.
Pause
If a drying cycle is being performed, it can be interrupted by pressing START/PAUSE. The appliance goes
into PAUSE mode and the corresponding LED begins to flash.
Press START/PAUSE to resume the drying cycle from the point at which it was interrupted.
2008-03 ADL 11/58 599 70 66 79