Bag F - Team Losi XXX Kiwald Edition Owner's Manual

Figure 51
!
Step 1. Inspect the inside of the tires [front (134), rear (135)] for any excess material. If present, trim excess rubber to ensure proper
seating of the tire on the wheel [front (136), rear (137)]. During tire assembly, make sure that all lettering faces to the outside of the
wheel.
*NOTE: Do not set tires on furniture as they may leave permanent stains.
!
Step 2. Insert the front foam tire liners (138) into the front tires (134). Pull the front tires (134) over the front wheels (136) and
squeeze the tires (134) to properly seat them into the grooves in the wheels (136). Make certain that the foam liners (138) are not
pinched between the tires (134) and the wheels (136).
!
Step 3. Insert the rear foam tire liners (139) into the rear tires (135). Pull the rear tires (135) over the rear wheels (137) and squeeze
the tires (135) to properly seat them into the grooves in the wheels (137). Make certain that the foam liners (139) are not pinched
between the tires (135) and the wheels (137).
!
Step 4. The tires (134), (135) must be glued to the wheels (136), (137). This can be done by using a fast-curing superglue or
!
cyanoacrylate glue available at your hobby shop. Be sure to follow the manufacturers' warnings on the bottle.
Team Losi Tread Lock (A-7880) is the best glue available for gluing R/C car tires. This glue was produced specifically for
this purpose.
IMPORTANT NOTE: Allow the glue to dry thoroughly before continuing. Read and follow adhesive manufacturers'
safety warnings regarding use.
!
Step 5. Install the front wheels (136) to the front stub axles (30) by lining up the hex on the axle (30) with the hex area in the front
wheel (136).
!
Step 6. Secure the front wheels (136) by threading a 4-40 locknut (110) onto each of the front axles (30) and tightening.
!
Step 7. Mount the rear wheels (137) to the rear axles (62) by lining up the pin (69) in the rear axle (62) with the groove in the rear
wheel (137) and pushing the wheel (137) all the way onto the axle (62).
!
Step 8. Secure the rear wheels (137) by attaching 8-32 locknuts (140) to the rear axles (62) and tightening.

BAG F

110
138
136
Figure 51
140
134
137
2 4
135
139