Team Losi XXX Kiwald Edition Owner's Manual page 34

Figure 62
!
Step 35. Trim the body (159) along the trim lines as shown in
Figure 62.
!
Step 36. Make four 1/4"-diameter holes at the locations marked
with dimples at the front, right side pod, and rear of the left and
right side pods of the body (159). These will be the body mount-
ing and antenna tube holes.
!
Step 37. Install the body (159) onto the rolling chassis and
secure it with body clips (155) through the post on the chassis
brace (147), and through the rear body mounts (151).
Figure 63
155
!
Step 38. Trim the rear wing (160) along the trim lines as shown
in Figure 63.
!
Step 39. Make two 5/32"-diameter holes in the wing (160) at
the locations marked with dimples.
!
Step 40. Place the rear wing (160) onto the rear wing mounts
(56) as shown in Figure 63. Place a wing mount washer (161) over
the post on each rear wing mount (56).
!
Step 41. Secure the rear wing (160) and wing mount washers
(161) to the rear wing mounts (56) by inserting a body clip (155)
through the hole in the post on each rear wing mount (56).
Finishing the Body and Wing
BODY AND WING PAINTING
Prepare the Lexan body shell and wing for painting by washing them thoroughly with warm water and liquid detergent. Dry both the
body and wing with a clean, soft cloth. Use the window masks (162) supplied to cover the windows from the inside. A high-quality
masking tape should be used on the inside of the body to mask off any stripes, panels, or designs that you wish to paint on the body
or wing. Use acrylic lacquer, acrylic enamel, or any other paints recommended for Lexan (polycarbonate). Apply paint to the inside
of the body and the bottom side of the wing. Remove the tape for the next color and continue. Try to use darker colors first. If you use
a dark color after a light color, apply a coat of white over the lighter color before applying the darker color. This will help prevent the
darker color from bleeding through the lighter color.
STICKERS
Cut the stickers from the sticker sheet (163) that you wish to apply to the body or wing. Before removing the protective backing, find
the desired location. Remove the backing completely and reattach an edge of the sticker to the shiny side of the backing material.
Using the rest of the backing material as a handle, position the sticker and press firmly into place to complete its application.
BAG G (Continued)
155
161
3 0
Figure 62
160
161
155
56
Figure 63