Table of Contents
Advertisement
Figure 10
27
!
Step 6. Insert a 3/16" x 3/8" sealed bearing (27) into each
side of both front spindles [left (28), right (29)].
!
Step 7. Insert a front stub axle (30) from the outside of both
spindles (28), (29) as shown in Figure 10.
!
Step 8. Place a front axle spacer (31) over each of the two
front stub axles (30) as shown in Figure 10. Thread a 4-40 x 1"
button-head screw (32) into each of the stub axles (30) from the
back side. The front axle spacer (31) should be positioned on the
stub axle (30) between the head of the screw (32) and the inner
bearing (27). Tighten the screws (32) while holding the stub axle
(30) with a 3/8" socket wrench or pliers.
*NOTE: If the 3/16" x 3/8" bearing only has one Teflon
!
(colored, woven-looking) in it, position the seal to the outside of the hub.
Be sure that the front axle screws are TIGHT! The
thread-lock compound that is on the screws takes 24 hours to
cure.
Figure 10A
!
Step 9. Attach the right spindle (29) to the right spindle car-
rier (34) by aligning the holes in each part and inserting a 3/32"
x 1.050" hinge pin (35) from the bottom. Do not insert the pin
(35) all the way through both parts yet.
!
Step 10. Insert a front spindle spacer (36) between the top of
the spindle (29) and the spindle carrier (34) as shown in Figure
11. Once the spacer (36) is in place, insert the hinge pin (35)
through the spacer (36) and the top of the spindle carrier (34).
Center the hinge pin (35) in the spindle carrier (34).
!
Step 11. Secure the hinge pin (35) with two 3/32" E-clips (37)
— one on each end.
IMPORTANT NOTE: There are two different sizes of
E-clips in this assembly bag. Be sure to use the smallest E-clips
on the 3/32" hinge pins. Refer to Figure 10A and make sure that
the spindles are installed correctly.
!
Step 12. Repeat Steps 9-11 for the left spindle (28) and left
spindle carrier (33).
BAG B (Continued)
32
31
35
36
30
™
seal
37
29
4
29
27
Figure 10
36
35
Figure 10A
31
32
34
37
Advertisement
Table of Contents
