Table of Contents
Advertisement
Figure 11
7
!
Step 13. Insert a 4-40 mini locknut (7) into the hex area in
each spindle carrier (33), (34) as shown in Figure 11. Insert a 1/4"
ball stud (10) into the outside hole (closest to the installed hinge
pin) and tighten.
!
Step 14. Insert a 4-40 mini locknut (7) into the hex area in
each spindle (28), (29). Thread a 1/4" ball stud (10) into the nut
from the bottom of the spindle (28), (29) and tighten.
IMPORTANT NOTE: Do not overtighten the ball
studs!
Figure 12
16
!
Step 15. Attach the right spindle and carrier assembly to a
front suspension arm (38) as shown in Figure 12. Note that the
spindle arm faces the side of the suspension arm (38) with the
shock mount holes (rear) and the ball stud (10) pointing forward.
Line up the holes in the spindle carrier (34) with the holes in the
front arm (38), insert a 3/32" x .930"" hinge pin (16) and attach a
3/32" E-clip (37) to both sides of the hinge pin (16).
IMPORTANT NOTE: There are two sizes of E-clips
in this assembly bag. Be sure to use the small E-clips on the
3/32" pins.
!
Step 16. Attach the arm (38) to the right side of the front
pivot block (39) by inserting a 1/8" x 1.42" hinge pin (40), from
the front, through the arm (38) and pivot block (39) as shown in
Figure 12.
!
Step 17. Insert a 1/8" E-clip (41) in the groove in the rear of
the hinge pin (40) only.
!
Step 18. Repeat Steps 14-16 for the left spindle and carrier
assembly and remaining front suspension arm (38).
!
Step 19. Slide the front hinge pin brace (42) over the front of
both inner hinge pins (40). The E-clip grooves in both hinge pins
(40) should be exposed in front of the brace (42). Secure the brace
(42) by attaching a 1/8" E-clip (41) to the front of each hinge pin
(40).
BAG B (Continued)
10
40
29
10
41
38
34
5
34
7
Figure 11
37
41
16
Figure 12
10
39
42
40
Advertisement
Table of Contents
