Table of Contents
Advertisement
Figure 58
!
Step 18. Insert a 4-40 x 3/8" flat-head screw (54) into each of
the two rear body mounts (151) from the side with the recess for
the head of the screw (54).
!
Step 19. Attach a rear body mount (151) to the rear of each
side of the chassis (19) so that the posts point, at an angle, to-
wards the rear of the car as shown in Figure 58. Secure the body
mounts (151) by tightening the screws (54). Apply the self adhe-
sive battery insulation tape (121) to both inner edges of the bat-
tery compartment as seen in Fig. 58A.
Figure 59
!
Step 20. Place the battery spacing foam (152) into the
recessed area in the rear of the chassis (19). The foam (152) should
be positioned against the rear shock tower (55).
!
Step 21. Remove the backing tape from the battery strap foam
strip (153) and attach it to the bottom side of the battery hold-
down strap (154).
IMPORTANT NOTE: The battery strap can be
mounted in one of two ways. The different offset will accommo-
date different styles of batteries. If you will be running matched-
type cells, or individual cells laid out side-by-side, the foam strip
should be attached on the side with ribs. The foam should be
positioned between these ribs. If, however, you are using a pre-
assembled stick pack, the foam strip should be attached to the
side of the strap opposite the ribs.
!
Step 22. Once the battery pack (not included) is installed,
the plastic battery strap (154) will hold the batteries in place. The
battery strap (154) fits under the rear "bridge" of the chassis (19),
between the two ribs on the bottom, and fits over the post on the
front chassis brace (147). The strap (154) is secured to the post
with a body clip (155).
BAG G (Continued)
54
155
121
Figure 58A
153
154
Figure 59
2 8
54
19
Figure 58
19
55
19
152
151
Advertisement
Table of Contents
