Bag C - Team Losi XXX Kiwald Edition Owner's Manual

Figure 18
41
!
Step 1. Insert a 1/8" x 1/4" washer (48) into the recessed area
on each side of the rear pivot block (49). Place the right rear
suspension arm (50) — marked 'R' — over the right side of the rear
pivot block (49). Line up the holes in the arm (50) with the holes
in the pivot block (49) and assemble the parts by inserting an
inner rear hinge pin (52) all the way through both parts. Install a
1/8" E-clip (41) to the rear end of the hinge pin (52).
!
Step 2. Repeat Step 1 for the left rear suspension arm (51).
!
Step 3. Slide the rear hinge pin brace (164) over the front of
both inner hinge pins (52). Secure the brace (164) by attaching a
1/8" E-clip (41) to the front of each hinge pin (52).
!
Step 4. Place the small anti-squat shims (165) to the side as
they will not be used (read the "Anti-Squat" section in "Tips" for
when to use these). Attach the rear pivot block (49) to the rear
pivot plate (53) with four 4-40 x 1/2" flat-head screws (44). Thread
4-0 mini nuts (7) over the exposed threads of the 4-40 x 1/2" flat
heads (44) and snug against the rear pivot block (49).
IMPORTANT NOTE: Ensure that the pivot block is
installed with the wider end to the rear as shown in Figure 18.
!
Step 5. Install the rear pivot plate (53) so that the pivot plate
(53) is flush with the chassis (19). Make sure that the four holes in
the chassis (19) line up with the holes in the pivot plate (53).
Secure the pivot plate (53) to the chassis (19) using four 4-40 x 3/8"
flat-head screws (54).
Figure 19
23
!
Step 6. Insert two 4-40 x 7/8" cap-head screws (23) — one on
each side — through the second hole out on the top of the rear
shock tower (55) as shown in Figure 19. Secure the screws (23) to
the shock tower (55) by threading a 4-40 nut (25) over each screw
(23) and tightening.
IMPORTANT NOTE: The screws should extend from
the same side of the shock tower as the two tabs near the center
of the tower.
!
Step 7. Thread a bluish ball stud (22) into the center hole on
each side of the rear shock tower (55). Place a "foam thing" (47)
over each of the two ball studs (22).
!
Step 8. Align a rear wing mount (56) with the lower holes in
the left side of the rear shock tower (55). Secure the wing mount
(56) with two 4-40 x 1/2" cap-head screws (57). Align and secure
the other wing mount (56) to the right side of the tower (55) in
the same manner.
IMPORTANT NOTE: The wing mounts should ex-
tend from the shock tower in the opposite direction of the screws
in the top of the tower as shown in Figure 19.

BAG C

48
52
25
22
165
54
57
23
56
47
8
44
7
19
164
48
165
49
54
53
Figure 18
55
25
22
Figure 19
50
52
41
57