Table of Contents
Advertisement
Table 53A
Figure 54
21
!
Step 9. Use Tables 53A and 53B to determine how the servo
!
mounting posts (146) should be attached to the servo (not included).
Trim any flashing from the pins on the mounting posts
so that they will seat all the way into the holes in the chassis
brace and chassis.
!
Step 10. Place a #4 washer (58) over each of the four
4-40 x 3/8" button-head screws (21) and attach the servo posts
(146) to the servo by threading a screw (21) through the upper
and lower holes in each post (146). Do not tighten the screws (21)
yet! Just snug them up so that the posts are held in place, but can
still be moved from side to side with a little resistance. The screws
(21) will be tightened after the servo is installed so that the posts
(146) have the correct spacing.
BAG G (Continued)
58
Table 53B
146
2 6
21
Figure 54
58
Advertisement
Table of Contents
