Team Losi XXX Kiwald Edition Owner's Manual page 33

Figure 60
!
Step 23. Cut a piece of two-sided tape (156) to the same size
as the bottom of the receiver (not included). Peel one side of the
backing off and stick the tape (156) to the bottom of the
receiver.
!
Step 24. Make sure that the area on the right side of the
chassis (19) is clean. Wipe this area off with a clean cloth or rag.
*NOTE: Rubbing alcohol can be used to clean any oily residue that
may be present on the chassis or receiver. Allow the alcohol to dry before
applying the two-sided tape.
!
Step 25. Peel the backing off of the two-sided tape (156) and
install the receiver to the right side of the chassis (19) with the
antenna wire exiting the receiver towards the front of the car as
shown in Figure 60.
!
Step 26. Run the antenna wire forward to the antenna post on
the chassis (19). Run the wire into the small hole in the bottom of
the post, and up through the top of the post.
!
Step 27. Slide the antenna wire through the antenna tube (157)
(a small drop of oil in the tube will make this easier) so that the wire
comes out the other end of the tube (157).
!
Step 28. While pulling the wire through the antenna tube
(157), slide the antenna tube (157) down and push it firmly into
the antenna mounting post on the main chassis (19).
!
Step 29. Fold the wire down over the antenna tube (157) and
place the antenna cap (158) over the tube (157) and excess wire.
*NOTE: If antenna wire is shorter than the tube, remove the tube
and cut off enough of the tube so that the wire will extend about 3/4"
past the end of the tube.
Figure 61
!
Step 30. Cut a piece of two-sided tape (156) to the same size
as the bottom of the speed control (not included). Peel one side of
the backing off and stick the tape (156) to the bottom of the speed
control.
!
Step 31. Make sure that the area on the left side of the
chassis (19) is clean. Wipe this area off with a clean cloth or rag.
*NOTE: Rubbing alcohol can be used to clean any oily residue that
may be present on the chassis or receiver. Allow the alcohol to dry before
applying the two-sided tape.
!
Step 32. Peel the backing off of the two-sided tape (156) and
install the speed control to the left side of the chassis (19) as shown
in Figure 61.
!
Step 33. Run the wire from the speed control through the
slot in the left rail on the chassis (19), across the center of the
chassis (19), and through the slot in the right rail of the chassis
(19).
!
Step 34. Plug the speed control wire into the channel 2 slot
in the receiver. Plug the wire from the servo into the channel 1
slot in the receiver.
BAG G (Continued)
Figure 60
Figure 61
2 9
158
157
19