Table of Contents
Advertisement
Figure 41
!
Step 49. Place the motor guard (111) over the rear of the
assembled transmission as shown in Figure 41.
!
Step 50. Secure the top of the motor guard (111) to the top of
the transmission by threading a 4-40 x 3/8" button-head screw
(21) through each of the two holes in the motor guard (111) and
!
into the gearbox halves (94), (97).
There is a short thread-cutting screw included in the
wrench bag. This screw can be used to tap threads in the holes in
the transmission case. Pre-tapping these holes makes it easier to
install the screws during assembly.
Figure 42
54
!
Step 51. Place the assembled chassis on a flat table so that the
rear suspension arms (50), (51) are flat and the chassis (19) is flat
on the table. This will make installing the transmission a little
easier.
!
Step 52. Insert the CVD's (59) into each of the outdrive/diff
halves (77) and place the transmission into the rear pivot block
(49). Push the transmission forward so that the top, center por-
tion of the transmission fits between the tabs on the rear shock
tower (55).
!
Step 53. Hold the rear arms (50), (51) up so that the CVD's
(59) stay in place, and turn the car over — holding the transmis-
sion in place while doing so. Align the two holes in the bottom,
rear of the transmission housing with the two holes in the rear of
the pivot plate (53).
!
Step 54. Apply a small amount of white assembly grease (87)
to each of the two 4-40 x 3/8" flat-head screws (54). Thread the
screws (54) through the two holes in the back of the rear pivot
plate (53), through the motor guard (111), and into the gearbox
halves (94), (97).
!
Step 55. Place a #4 washer (58) over the 4-40 x 1-1/2" cap-
head screw (112). Thread the screw (112) through the hole in the
left side of the rear shock tower (55), through both gearbox halves
(94), (97), and into the motor plate (96).
*NOTE: In order to properly align all parts, it may be necessary to
pull the transmission forward while inserting the screw.
IMPORTANT NOTE: Ensure that the screw is
threaded into the motor plate.
BAG D (Continued)
21
112
58
97
94
111
112
58
111
53
1 9
21
Figure 41
55
77
49
59
54
Figure 42
19
51
Advertisement
Table of Contents
