Using Fax Mode; Using Tel Mode - Sharp UX-A760 Operation Manual

Using FAX Mode

To select FAX mode, press
(with no document in the feeder) until
appears in the display.
[FAX]
In FAX mode, the machine
automatically answers all calls on two
rings and receives incoming faxes.
♦
If you pick up a phone connected to
the same line before the machine
answers, you can talk to the other
party and receive a fax as explained in
Using TEL Mode on page 27.
Number of Rings setting
To change the number of rings on which
the machine answers calls in TEL/FAX
mode and FAX mode, follow the steps
below. Any number from 2 to 5 can be
selected.
Initial setting: 2 rings
1 F
Press ,
2
Enter the desired number of rings
(any number from 2 to 5).
Example:
3
Press to exit.
, , and .
(4 rings)
Using FAX Mode

Using TEL Mode

To select TEL mode, press
(with no document in the feeder) until
[TEL] appears in the display.
In TEL mode, you must answer all calls
(even faxes) by picking up the
machine's handset or an extension
phone connected to the same line.
Important: If a document is loaded in
the machine's feeder, remove it before
performing either procedure below.
Answering with the machine's
handset
1
When the machine rings, pick up
the handset.
2
If you hear a fax tone, wait until the
display shows [RECEIVING] and
then replace the handset.
•
If [RECEIVING] does not appear,
START
press to begin reception.
(This is necessary if you have set the
Fax Signal Receive setting to NO
(page 29).)
3
If the other party first speaks with
you and then wants to send a fax,
START
press after speaking.
(Press before the sender presses
their Start key.)
•
When [RECEIVING] appears in the
display, hang up.
27